Final Assembly; Testing And Adjustments - Health Zenith SL-4110 Installation And Operating Instructions Manual

FinaL asseMBLy

1. Push the wires into the junction box. Make
sure the wires from the fixture go through the
wire path and no wires get pinched.
2. Slide the fixture assembly onto the mounting
screws. Tighten decorative nuts removed in step
1 of Installation section securely against fixture
base.
Decorative Nut
3. Install one medium base light bulb (100 Watt
maximum).
4. Caulk around fixture base with silicone weather
sealant.
598-1358-01
Junction Box
Mounting Screw

testinG anD aDjustMents

1. Turn on the circuit breaker and light
switch.
Note: Sensor has a 1
before it will detect motion. When first turned
on wait 1 / minutes.
1
2
2. Set:
ON-TIME switch to TEST
SENSITIVITY dial to Midway
TEST 1 5 10
MINUTE
5
/ minute warm up period
1
2
– +
SENS