LG DL 730 E Series Owner's Manual page 17

WARNING
• The edges of the door cover may be sharp. Take
care when handling, or wear gloves to avoid
injury.
2
Switch the door strike
.
b
• Remove the two screws on the door cover
that secure the door strike. Remove the
blank cover by pulling and raising.
Switch the door strike and the blank cover,
installing them on the opposite sides from
which they were removed.
• Gently pry out the hole plug on the side of
the door cover and install it in the hole on
the opposite side. Set the door cover aside.
and the blank cover
a
3
Reverse the components inside the door.
• You will now be removing and reversing
various components inside the door. See a
few page later for a detailed diagram and
identification of the inner structure and
parts of the door. (The diagram shows the
"before view" of the door, with the default
set-up for a right side hinge swing. After
following these instructions, your door
should be a mirror image of the illustration.)
4
Lift out the gray interlock button in the side of
the door.
• Make sure to remove the spring with the
interlock button and to keep the two
together. Set the interlock button aside. Do
not confuse these with the interlock buttons
from the top of the outer door.
5
Remove the side lock rod.
• Remove the side lock rod from the lower
hinge bracket by lifting the top end of the
rod and sliding it toward the top of the
door. The spring should remain attached to
the lock rod. Set the lock rod aside.
6
Remove the top lock rod.
1) Slide the lock rod to the right to remove it
from the hinge assembly on the left side.
INSTALLATION 17