Craftsman 919.728001 Owner's Manual page 11

6. If the handle has excessive
movement, it is improperly
installed. Check the following.
A. Are both tabs inside the
handle (Step #3)?
B. Does each clip pass through
both the saddle and handle
(Step #4)?
To Assemble Wheels
support one side of the unit when
installing the wheels because the
compressor will have a tendency
to tip.
1. Attach wheels with shoulder
bolts and nuts as shown.
Nut
Shoulder Bolt
2. Tighten securely. NOTE: The
unit will sit level if the wheels are
properly installed.
It will be necessary
to brace or
Wheel
provide adequate clearance,
stability or support for pulling the
unit up and down stairs or steps.
The unit must be lifted, or pushed
up a ramp.
Assemble Rubber Feet
1. Attach rubber feet with the
screws, washers, and nuts
provided as shown.
2. Tighten securely.
11 - ENG
The wheels and
handle do not
Nut
Flat
Washer
Rubber Foot
Screw
A15256