Table of Contents
Advertisement
Press down on the insert and re-
2.
move the detergent drawer.
Insert the measuring aid.
3.
Insert the detergent drawer.
4.
13.6 Adding detergent and
care product
Notes
Do not use the measuring aid for
¡
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
Observe the information about de-
¡
tergents and care products
→ Page 28.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.7 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 28
Press
Start / Reload.
▶
The drum rotates and load detec-
a
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
The display shows the programme
a
duration or the programme end
time.
After the programme has ended,
a
the display shows: "End".
13.8 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
The programme is set.
¡
→ "Setting a programme", Page 28
The programme end time is set
¡
and activated.
→ "Buttons", Page 22
Press
Start / Reload.
1.
The activated programme end time
is paused.
Press
Finish in until the display
2.
shows the required programme
end time.
Press
Start / Reload.
3.
The changed programme end time
is activated.
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press
Reload.
operation en
Start /
29
Advertisement
Table of Contents
