Table of Contents
Advertisement
Quick Links
7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON | Fax: 951.689.1016
COMPONENTS INCLUDED
(2) 194801E-AL 21-23 F150 4WD TREMOR REAR
2.5 AL VS PB CDEV UPKG
HARDWARE INCLUDED
(8) 257164 HEIM SPACER COM10 SPACER X .500
X 1.500 CZINC
TOOLS REQUIRED
JACK
JACK STANDS
PRY BAR
TORQUE WRENCH
TECH NOTES
1. ESTIMATED INSTALL TIME: 1-2 HOURS,
2. YOUR ICON SHOCK ASSEMBLIES COME FACTORY CHARGED TO 150 PSI. RELEASING NITROGEN
PRESSURE MAY LEAD TO SHOCK MALFUNCTION AND REDUCED RIDE QUALITY. FAILURE CAUSED BY
LOW NITROGEN PRESSURE IS NOT COVERED UNDER ICON'S WARRANTY POLICY.
INSTALLATION
1.
Using a properly rated jack, raise the rear of the vehicle and support
the frame rails with jack stands. Ensure the jack stands are secure and set
properly before lowering the jack. NEVER WORK UNDER AN UNSUPPORTED
VEHICLE.
PART #
97721EP
(2) 255604-26 EXTENSION HARNESS COIL 26 FT
15MM SOCKET / WRENCH
18MM SOCKET / WRENCH
FIG.1
97721EP INSTALLATION INSTRUCTIONS
DESCRIPTION
21-23 F150 4WD TREMOR REAR 2.5 AL VS
PB CDEV PAIR
WARNING!
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLATION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON'S WARRANTY POLICY.
2.
Remove the factory rear shocks using a 15mm and
an 18mm socket/wrench. [FIGURE 1]
8-9-2023 REV.A
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ICON 97721EP
Summary of Contents for ICON 97721EP
- Page 1 1. ESTIMATED INSTALL TIME: 1-2 HOURS, WARNING! 2. YOUR ICON SHOCK ASSEMBLIES COME FACTORY CHARGED TO 150 PSI. RELEASING NITROGEN PRESSURE MAY LEAD TO SHOCK MALFUNCTION AND REDUCED RIDE QUALITY. FAILURE CAUSED BY ** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH LOW NITROGEN PRESSURE IS NOT COVERED UNDER ICON’S WARRANTY POLICY.
- Page 2 The passenger side upper shock mount needs to be sanded slightly in order for the ICON shock to fit. [FIGURE 2 & 3] FIG.2 FIG.3 Paint all exposed metal to prevent rust. Install the ICON rear shocks using a 15mm and an 18mm socket/wrench. The reservoir points away from the axle.
- Page 3 ICON VEHICLE DYNAMICS SHOCK ABSORBER WARRANTY This shock absorber has a 1 year warranty against any manufacturer’s defects. If a shock fails within the initial year of ownership, the shock must be shipped to ICON Vehicle Dynamics for inspection and service. If a shock is inspected and it has been determined the shock failed due to neglect, damage caused by improper installation or any other reason besides “normal wear and tear”, the owner of said shock is responsible for all service costs.
Need help?
Do you have a question about the 97721EP and is the answer not in the manual?
Questions and answers