Dealer Checklists - Woods RT42.30 Operator's Manual

DEALER PRE-DELIVERY CHECKLIST
(DEALER'S RESPONSIBILITY)
Inspect the equipment thoroughly after assembly to
make sure it is set up properly before delivering it to the
customer.
The following check list is a reminder of points to in-
spect. Check off each item as it is found satisfactory,
corrections are made, or services are performed.
Check that all safety decals are installed and in
good condition. Replace if damaged.
Check that all shields and guards are proper-
ly installed and in good condition. Replace if
damaged.
Check all bolts to be sure they are properly
torqued.
Check and grease all lubrication points as iden-
tified in the Lubrication Maintenance illustration,
page 17.
Check the level of gearbox fluids before delivery.
Service, if required, as specified on page 17.
Check that blades have been properly installed.

26 Dealer Checklists

DEALER CHECKLISTS
DELIVERY CHECKLIST
(DEALER'S RESPONSIBILITY)
Show customer how to make adjustments and
select proper PTO speed.
Instruct customer how to lubricate and explain
importance of lubrication.
Point out the safety decals. Explain their mean-
ing and the need to keep them in place and in
good condition. Emphasize the increased safety
hazards when instructions are not followed.
Point out all guards and shields. Explain their im-
portance and the safety hazards that exist when
not kept in place and in good condition.
Present Operator's Manual and request that cus-
tomer and all operators read it before operating
equipment. Point out the manual safety rules,
explain their meanings, and emphasize the in-
creased safety hazards that exist when safety
rules are not followed.
Explain to customer the potential crushing haz-
ards of going underneath raised equipment.
Instruct customer that service work does not re-
quire going underneath unit and never to do so.
Explain to customer that when equipment is
transported on a road or highway, safety devices
should be used to give adequate warning to op-
erators of other vehicles.
Inform customer to operate PTO at 540 rpm
maximum.
Explain to customer the importance of having the
correct PTO driveline length so that it does not
bottom out or come apart. Explain that it must be
checked as instructed in the manual whenever
using a different tractor.
Show customer the safe, proper procedures to
be used when mounting, dismounting, and stor-
ing equipment.
MAN1177
( 07/28/2023 )