Table of Contents
Advertisement
This submenu allows you to change voltage and clock of various devices.
Note
»
We suggest you use the default setting. Changing the voltage and clock improperly may damage the
device.
»
The options and default settings might be different by RAM or CPU models.
»
Beware of that setting inappropriate values in items of this menu may cause system to malfunction.
- Values in Red: Danger
- Values in Yellow: Warning
- Values in White: Normal
Start Page
You can set the entrance page when you enter UEFI BIOS Setup.
Options: Page – Main (Default) / Page – Advanced / Page – Chipset / Page – Boot / Page – Security
/ Page –O.N.E / Page – Save & Exit
Note
»
The following two items are only for Z170 chipset motherboard.
Clock Frequency
Specifies new frequency to be applied. Frequency is rounded to nearest valid value. Allowed
range is limited by the Max/Min supported frequencies. Changes are not applied until settings are
saved and platform resets.
Spread %
Specifies the amount of spread spectrum clocking to be applied to the base clock frequency in
0.01% increments. Allowed range is limited by Maximum Spread % and supported Spread mode
Adjustments. If Changes Allowed, a value between 0 and Max Spread % can be specified. Value is
adjusted to settings supported by HW. If only Halt Allowed, only 0% and default spread % can be
specified. Changes are not applied until settings are saved and platform resets.
6� O�N�E Menu
Hi-Fi Z170Z5 / Hi-Fi B150Z5
6. O.N.E Menu | 27
Advertisement
Table of Contents
