Olimpia splendid CALDO SKY Instructions For Use And Maintenance Manual page 29

• DO NOT install the appliance beneath power outlets.
• Prepare a power outlet in the vicinity of the appliance making
sure it's not too far in relation to the power cord length (figure
C).
a. Locate the area where the appliance is going to be installed.
b. Create two due 6mm holes with a centres distance of 315mm (figure D).
• The holes must be at least 2000mm away from the floor 350mm
from the ceiling (figure D).
• When piercing the wall, make sure that no electrical channels or
water hoses are present.
c. Insert the wall plugs in the holes and then fasten the supplied screws.
d. Do not fasten the screws entirely; leave them approximately 10 mm away from the wall
(figure E).
Make sure that the screws are well steady in the wall.
e. Place the slots (X) on the rear part of the appliance on the screws pushing the appliance
itself against the wall (figure F - phase 1).
f. Push the appliance 10 mm towards the left (figure F - phase 2) then push it about
8÷10mm downwards (figure F - phase 3).
g. Lastly, check that the appliance is steady and well attached to the wall.
• Before connecting the appliance plug to the power outlet, make
sure that the voltage values indicated on the data plate corre-
spond to the mains supply ones and that the outlet is equipped
with an efficient grounding.
• The socket must be easily accessible so that the plug can be
removed easily in an emergency.
h. Insert the plug in the power outlet.
i. Press "I" (ON) on the switch (6); the appliance is ready for use.
This product has a flap that opens automatically when the product is
turned on and closes automatically when turned off. DO NOT MOVE
THE FLAP WITH YOUR HANDS.
As this could damage or deform the unit. Open the flap with your hands
only if it accidentally closes in part or in whole.
CALDO SKY
EN - 9