Working Without The Automatic Levelling System; Practical Guidance; Working With The Tripod - Parkside 322432-1901 Translation Of The Original Instructions

Crossed lines can be locked with this product:
When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less than
4° (green LED on) hold down the H-button
tor goes red. Now automatic levelling is switched off and the
2
crossed lines are permanently switched on - even if the base of the
measurement device deviates from the horizontal by more than 4°.
You can turn this mode off again by pressing and holding down the
H-button
1
matic levelling system has been switched on again.
The crossed lines are turned off as soon as the base of the measuring tool
deviates from the horizontal by more than 4°, and the LED indicator
will turn red again.
Working without the automatic
levelling system
Put the LOCK switch
Hold down the H-button
on. Now the product will release two laser lines from the laser
beam opening
levelling will always be indicated via the red LED indicator

Practical guidance

Always use only the middle of the laser line for markings. The width
of the line depends on the distance.

Working with the tripod

Setup and alignment
1. Pull all the three legs
which is connecting all the three cross hinges will be moved to the
end of the middle column.
2. Release the blocking levers
your desired height.
3. Then, fold-back all those blocking levers
4. Check the straight positioning by using the bubble level
tripod is straight, the air bubble will be positioned in the centre of
the circle. If necessary, readjust the length of the legs
until the LED indicator
into the position .
4
until the red LED indicator
1
that are not levelled. Operation without automatic
7
of the tripod apart. The plastic ring
17
16
until the LED indica-
1
goes green again. The auto-
2
and extend the legs until you get
.
16
2
comes
2
.
2
,
15
. If the
11
.
17
GB/IE 25