Breville the Smart Air Connect Purifier Instruction Book page 10

Table of Contents

Advertisement

FAN SPEED/TURBO MODE
NOTE
The air purifier will resume in the last
programmed setting once it has been turned
off, even if turned off at the power outlet. If the
last programmed setting was Night mode, once
turned on, the control panel will illuminate
with the Night indicator light blinking as a
reminder that Night mode has been set.
• Press the
FAN SPEED button repeatedly
until the desired speed is illuminated on the
control panel.
• There are 4 fan speeds: Low, Medium, High
and Turbo.
• The purifier has reached Turbo mode when
all three lights are illuminated on the control
panel at the same time.
NOTE
When changing the fan speed, the unit may
take a few seconds to adjust.
TIMER
• The air purifier can be set to operate for
timed intervals of 2 hours, 4 hours and 8
hours, stopping automatically when the
selected operating time has elapsed. If no
timer is set, the air purifier will continuously
operate until it is manually switched off.
• Press the
TIMER button repeatedly until
the desired interval hours are illuminated on
the control panel.
• For continuous operation, press the
TIMER button repeatedly until there are no
lights illuminated under the timer intervals.
10
AUTO MODE
• When in Auto mode, the air purifier will
automatically adjust the speed to help filter
the air based on the sensor reading.
• To set to Auto, press the
continuously until the Auto indicator light
illuminates.
• Press the
POWER button or the Fan
Speed button, to turn Auto off and beneath
Auto indicator light will extinguish.
IMPORTANT
Turning the unit On and Off will require
cycling through the Auto mode.
FILTER RESET
• The Filter reset light will blink continuously
indicating that the filter needs to be replaced.
• Replace the filter according to the directions
found under Replacing the Filter in this book.
• Once the filter is replaced, press and hold
the
Microbe Shield
Reset button for 5 seconds to reset the Filter
Reset light.
• The built-in timer for the filter reset is 4,320
operating hours.
NOTE
For best performance, the filter should be
cleaned at least monthly as per the Instructions
found in the Care, Cleaning & Storage section
of this book.
POWER button
/Night Mode/Filter
TM

Advertisement

Table of Contents
loading

Table of Contents