Biostar B660GTN User Manual page 19

Device power-up delay
Maximum time the device will take before it properly reports itself to the Host Controller.
"Auto" uses default value: for a Root port it is 100ms, for a Hub port the delay is taken from Hub
descriptor.
Options: Auto (Default) / Manual
Note
» The following items appear only when you set the Device power-up delay function to [Manual].
Device power-up delay in seconds
Delay range is 1 ~ 40 seconds, in one second increments.
Options: 5 (Default)
USB FLASH DRIVE PMAP
This item Mass storage device emulation type. 'AUTO' enumerates devices according to their
media format. Optical drives are emulated as 'CDROM' , drives with no media will be emulated
according to a drive type.
Options: Auto (Default) / Floppy / Forced FDD / Hard Disk / CD-ROM
Network Stack Configuration
Network Stack
This item enables or disables UEFI network stack.
Options: Disabled (Default) / Enabled
Note
» The following items appear only when you set the Network Stack function to [Enabled]
IPv4 PXE Support
This item enables or disables IPv4 PXE Boot Support. If disabled IPv4 PXE boot support will not
be available.
Options: Disabled (Default) / Enabled
B660GTN
2. Advanced Menu | 19