Electrical Connection; Start Up; Preliminary Preparation - Beko B5W1241AW User Manual

4.7 Electrical Connection

Connect the product to a grounded outlet
protected by a 13 A fuse. Our company
shall not be responsible for the damages
that shall be incurred due to using the
product without grounding according to
local regulations.
• Connection must comply with national
regulations.
• The electrical connection cable infra-
structure of the product must be ad-
equate and suitable for product require-
ments. It is recommended to use a
Ground Fault Circuit Breaker (GFCI).
• Power cable plug must be within easy
reach after installation.
• If the current supply to the fuse or
breaker in the house is less than 13
Amps, have a qualified electrician install
a 13 amp supply.
• The voltage specified in the "Technical
specifications" section must be equal to
your mains voltage.
• Do not make connections via extension
cables or multi-plugs. Overheating and
burning may occur due to the connecting
cable.
Damaged power cables should be
replaced by the authorised service
in order to prevent possible danger.
Important
Fitting a different plug:
As the colours of the wires in the mains
lead of this appliance may not correspond
with the coloured markings identifying the
terminals on your plug, proceed as follows:
1. Connect the green - yellow or green
(earth) wire to the terminal in the plug
marked 'E' or with the symbol f or col-
oured green and yellow or green.

5 Preliminary Preparation

Please read the "Safety Instruc-
tions" section first!
2. Connect the blue (neutral) wire to the
terminal in the plug marked 'N' or col-
oured black.
3. Connect the brown (live) wire to the ter-
minal in the plug marked 'L' or coloured
red.
With the alternative plugs a 13 A fuse must
be fitted either in the plug or adaptor or in
the main fuse box. If in doubt contact a
qualified electrician.

4.8 Start Up

Before starting to use the product make
sure that the preparations described in sec-
tion "Environmental instructions" and "In-
stallation". To prepare the product for
washing laundry, perform first operation in
Drum Cleaning programme. If this pro-
gramme is not available in your product, ap-
ply the method which is described in sec-
tion "Cleaning the loading door and the
drum".
Some water has remained in the
product due to the quality control
processes in the production. It is
not harmful for the product.
EN / 14