Nova 9131-R How To Assemble

HOW TO
ASSEMBLE YOUR
ADJUSTABLE BATH
SEAT WITH BACK
Item # 9131/9131-R
Capacity not to exceed 500 lb
a. (1)
b. (4)
a.
1
Place the seat face down on a level surface.
Insert legs into the four corners of the seat.
Depress the push button at the tip of the leg,
and push the leg into the seat until the push
button protrudes out of the hole. The push
button should snap and lock the leg into
position.
Adjust all legs to the same desired height by
depressing the push button and sliding the leg
up or down. Slightly twist each leg to ensure
push buttons are fully engaged and stable.
2
Turn the seat on its side so that the
backrest cutouts face upward. Place
backrest tube against the bottom of
the seat and align the tubing and screw
holes. The end of the backrest tube with
the push button will point away from
the legs.
Insert knobs with washers into the
screw holes. Tighten knobs to secure
backrest tubes to the seat. Repeat for
the other side.
3
Place bath seat on its legs and install the
backrest onto the backrest tubes. Depress push
buttons on the backrest tubes and slide the
backrest down until it snaps into place and is
secure. Ensure all parts are secure before using
bath seat.
*Revised May 22, 2017
WHAT'S IN THE BOX
Seat
Adjustable legs
b.
c. (1) Backrest
d. (2) L-shaped backrest tubes
e. (4) Knobs with washers
c. d.
NO tools required.
Quick installation.
Easy to follow
step-by-step
instructions
e.