Profi-pumpe INVERT-TEC 600 Operating Instructions Manual page 4

4 English
8. RECOGNISING AND REPAIRING OF MISTAKES
Problem
Pump runs, no water is being
pumped
Pump does not start or switches
itself off
Pump runs, Pump capacity slows
down or stops
9. NOTES ON PRODUCT LIABILITY
We point out, that we are only liable for damages under the Product Liability Act, which are caused by our units if
no changes were made to the equipment. If repairs are carried out by our authorized service, we are only liable if
original spare parts and accessories were used.
10. NOTES ON DISPOSAL
Electro devices of our company, labeled with the symbol of the crossed trash bin, are not permitted to
be disposed in your household garbage. We are registered at the German registration department EAR
under the WEEE-No. DE79535656. This symbol means, that you're not allowed to treat this product as a
regular household waste item – it has to be disposed at a recycling collection point of electrical devices.
This is the best way to save and protect our earth.
THANK YOU FOR YOUR SUPPORT!
11. EU DECLARATION OF CONFORMITY
The undersigned, Amur S.à r.l., 36, Rue de la Gare, L-5540 Remich, certifies that the product named overleaf,
namely INNO-TEC 600 / 1200 / 1300 as placed on the market, complies with the relevant provisions listed below, the
relevant EU harmonised directives and the EU standard for safety. This declaration of conformity applies insofar as
no modifications are made to the product. The sole responsibility for issuing this declaration of conformity lies with
the manufacturer.
The sole authorised person to keep the technical documents:
Amur S.à r.l. - 36, Rue de la Gare - L-5540 Remich
Valid for pumps INNO-TEC 600 / 1200:
Machinery Directive 2006/42/EC
Low Voltage Directive (2014/30/EU)
EC Electromagnetic compatibility directive (2014/30/EU)
The following harmonized standards:
EN IEC 55014-1:2021; EN IEC 55014-2:2021;
EN IEC 61000-3-2:2019+A1;
EN IEC 61000-3-3::2013+A1
RoHS: 2011/65/EU
Signed for and on behalf of:
Amur S.à r.l.
Remich, 20.02.2023
i.V. Dipl. Phys. Peter Neumüller
Technical Manager
Possible cause
Air in the suction line
Air in the system (cannot escape)
Impeller wheel is blocked
Engine guard has switched the
pump off
No electricity
Pump is inserted to deep
Hose connections systems have
a leak
Impeller wheel is worn down
Filter has become dirty
Valid for pump INNO-TEC 1300:
Low Voltage Directive (2014/30/EU)
EC Electromagnetic compatibility directive (2014/30/EU)
The following harmonized standards:
EN IEC 55014-1:2021; EN IEC 55014-2:2021;
EN IEC 61000-3-2:2019+A1;
EN 61000-3-3:2013+A1+A2
RoHS: 2011/65/EU
Solution
Check suction line and connections
for vacuum tightness
Air in the system must be let out
Impeller wheel must be cleaned
Pump needs to be cooled
Check electrical connections
Insert pump not so deep
Check hose connection systems
Change impeller wheel
Clean filter