Craftsman CMXGKAM212501 Instruction Manual page 7

Securing Blade Depth Control Cable
Unwrap the blade depth control cable and route it up the right side of the handle.
1. Pull the depth control lever out of the first position of the depth
control bracket.
2. Push lever all the way forward.
3. Release lever into last position of bracket.
4. Hook the Z end of the depth control cable into the hole on the depth control
lever as shown in Figure 4.
2
3
Starter Rope
1. Locate the rope guide and wing knob found in the manual bag. Using the
wing knob, secure but do not tighten the rope guide to the right side of the
upper handle as shown in Figure 5.
3
1
4
Figure 4
1
2
4
Figure 5
ASSEMBLY
2. Stand behind the edger and hold the blade control against the upper handle.
3. Gently pull the starter rope out of the engine.
The edger blade WILL rotate when the starter rope is pulled.
NOTE: The starter rope will not pull out of the engine unless the blade
control (refer to Figure 5) is depressed against the upper handle.
4. Slip the starter rope through the top of the rope guide. Tighten the wing
knob which secures the rope guide to the upper handle.
Adjustments
Bevel Adjustment (If equipped)
1. The angle of the edger blade can be adjusted by placing the bevel
adjustment lever in one of three positions for edging. See Figure 6.
7
WARNING
Figure 6