Table of Contents
Advertisement
Selecting an Input Source
The projector can be connected to multiple devices at the same time. However, it
can only display one full screen at a time.
If you want the projector to automatically search for the input source, ensure the
Quick Auto Search function in the SYSTEM menu is On.
The Input Source can also be manually selected by pressing one of the source
selection buttons on the remote control, or by cycling through the available input
sources.
On
Of f
COMP
HDMI 1
HDMI 2
Auto
Source
Sync
To manually select the input source do the following:
1. Press Source, and a source selection menu will appear.
2. Press
until your desired signal is selected and press Enter.
/
3. Once detected, the selected source information will be displayed on the screen
for a few seconds.
NOTE:
If there are multiple devices connected to the projector, repeat steps 1-2 to
search for another source.
27
Advertisement
Table of Contents
