Infinitum Aircore EC Quick Start Manual

Aircore EC
Quick Start Guide
This guide contains general procedures for Infinitum EC Aircore motors
and is not intended to provide a full list of installation details, operation
and maintenance. These additional details can be found in the Infinitum
Aircore EC IOM Manual. Only qualified personnel should install and operate
Infinitum Aircore EC motors. All motors have default settings.
This document includes Cautions and Warnings that should be read
in advance of installation or operation.
Unpacking and inspection
Motors are tested and packed individual crates or 4 motors per crate.
1. Inspect the motor packing for damages during shipping. If the package is
damaged, remove the packing and inspect the motor for damage. Motor
damage from shipping must be reported to the shipper.
2. Review the data on the nameplate with your purchase order to verify that you
have received the correct motor. Compare data on name plate for desired
power supply and control equipment requirements.
3. The motor is provided with two lifting eyebolts to remove the motor from its
packing crate.
Warning: To reduce the possibility of personal injury or death these eyebolts
are intended to lift the motor and drive assembly only. Attaching the
component it drives (i.e. fan, pump, etc.) may exceed the design weight
limits of the eyebolts. Make sure the eyebolts are threaded completely into
the motor housing to ensure they do not rotate out during lifting. Use an
approved lifting device (crane) and sling to remove the motor from the
packing crate.
Electrical supply and control wiring
Infinitum Aircore EC motors are pre-programmed to run utilizing remote inputs
wired to the Control & Communication PCB connections once the appropriate
power connections are provided. The default configuration for all motors is
Modbus. Analog/Digital control is also available (user configurable).
Warning: The rotor in this motor incorporates a Permanent Magnet (PM)
design. When the rotor is rotated a voltage is produced in the stator even
when the motor is disconnected from a power source. Do not open electrical
compartments or touch unprotected terminals while the rotor is turning.
Disconnect motor supply power and allow one minute for capacitors to
discharge before servicing or replacing. Failure to comply with rotor safety
procedures can cause serious injury or death and equipment damage.
Infinitum 20230810
Safety
Infinitum Aircore EC motors
operate with high voltages and
can cause serious or fatal injuries.
Only qualified personnel should
attempt installation, operation
and maintenance of electrical
equipment. Unsafe installation or
use can cause conditions that lead
to serious or fatal injury.
Mounting
Star mounts
C-face