Steps
1. Align the screw holes on the heat sink with the screw holes on the system board.
2. In sequential order (1 > 2 > 3 > 4), as indicated by the numbers on the heat sink, tighten the four screws (M2x6.5) that
secure the heat sink to the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Removing the heat sink (for computers shipped with discrete
graphics card)
Prerequisites
1. Follow the procedure in
CAUTION:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
2. Remove the
base
cover.
About this task
The following image indicates the location of the heat sink and provides a visual representation of the removal procedure.
34
Removing and installing components
After working inside your
Before working inside your
computer.
computer.