Related Manuals for iCONNECT PRL-60-240
Summary of Contents for iCONNECT PRL-60-240
- Page 1 INSTALLATION INSTRUCTIONS PROJECTOR LIFT Thank you for buying iConnect products. The PRL is the latest technology in projector lifts. PRL-60-240 Please read this manual carefully before assembling.
- Page 2 CONTENTS iCONNECT MAIN CONTENTS SAFETY OVERVIEW 5-6. LIFT PREPARATION 7-10. LIFT INSTALLATION 11-12 / 16-17. FINISHING THE CEILING LIFT 13-15. ADJUSTMENTS FINISH DIMENSION TECHNICAL SPECIFICATION...
- Page 3 SAFETY iCONNECT Projector lift PRL-60-240 must be installed by specialized personnel only. Before installing the projector lift, please read the following instructions carefully 1. The projector lift must be used indoors only. 2. It is forbidden to stay under the lift.
- Page 4 OVERVIEW iCONNECT Lift Frame Pulley Limit Switch Motor Linkage Lift Frame Projector Mount Projector Adjustable Mount Plate...
-
Page 5: Lift Preparation
LIFT PREPARATION iCONNECT Remove the 8 screws Remove Adjustable Mount Plate... - Page 6 LIFT PREPARATION iCONNECT 600mm 600mm Open a hole in the ceiling...
-
Page 7: Lift Installation
LIFT INSTALLATION iCONNECT The direction of the screen Mark and drill 4 holes in the ceiling with a diameter of 10 mm... - Page 8 LIFT INSTALLATION iCONNECT Tighten bolts through the holes designated lift and strong Make sure you locked well...
- Page 9 LIFT INSTALLATION iCONNECT Use a power cable that came with the package. plug the male and female side motor Connect the other end of the cable to a power source 110 V Press the switch and lower the lift down...
- Page 10 LIFT INSTALLATION iCONNECT Unplug the projector arm by opening the screw at the top...
- Page 11 FINISHING THE CEILING LIFT iCONNECT Create a wooden surface thickness of 12 mm and set it with 9 screws...
- Page 12 FINISHING THE CEILING LIFT iCONNECT Reconnect Adjustable Mount Plate...
- Page 13 ADJUSTMENTS iCONNECT Stop and drop tuning of the lift is preformed by allen plastic screwdriver supplied only The motor two allen screws, one controls the rotation decrease and second rounds of closing...
- Page 14 ADJUSTMENTS iCONNECT Adjust the height of the closure with a ceiling...
- Page 15 ADJUSTMENTS iCONNECT Adjust the desired opening height...
- Page 16 FINISHING THE CEILING LIFT iCONNECT 454mm Create a wooden surface close to the desired size, please leave a margin of 2 mm on each side main square...
- Page 17 FINISHING THE CEILING LIFT iCONNECT Set the wood surface with a ceiling and make sure it is installed in the desired location...
- Page 18 FINISH iCONNECT install the projector on the arm and return it to the designated place in the lift, set the projector to the desired location Enjoy the product (-;...
- Page 19 DIMENSION iCONNECT...
-
Page 20: Technical Specification
TECHNICAL SPECIFICATION iCONNECT Product Code PRL-60 PRL-120 PRL-180 PRL-240 Control Options Contact closure / RF Contact closure / RF Contact closure / RF Contact closure / RF Finish / Custom White RAL 9016 White RAL 9016 White RAL 9016 White RAL 9016...