12-Drive Enclosure Front Panel Leds - Phoenix International RPC24 694 Series Setup Manual

12-drive enclosure front panel LEDs

The enclosure bezel is removed to reveal the underlying 2U12 enclosure front panel LEDs. The front panel
LEDs—including LFF disk LEDs—are described in the table below the illustration.
Left ear
1
Notes: Enclosure bezel is removed to show front panel LEDs.
Integers on disks indicate drive slot numbering sequence.
LED Description
1 Enclosure ID
2 Disk drive — Upper LED
3 Disk drive — Lower LED
4 Unit Locator
5 Fault/Service Required
6 FRU OK
7 Temperature Fault
The enclosure bezel for this model provides the EMI protection for the LFF disk drive modules. The bezel should
be securely attached to the enclosure during operation (see
on page 70).
CAUTION: Whether configured with or without an air filter, to ensure adequate EMI protection for the LFF
disk drives, the enclosure bezel should be properly installed while the enclosure is in operation.
0
4
8
2 3
Definition
Green — On
Enables you to correlate the enclosure with logical views presented by
management software. Sequential enclosure ID numbering of controller
enclosures begins with the integer 0. The enclosure ID for an attached drive
enclosure is nonzero.
See
See
White blink — Enclosure is identified
Off — Normal operation
Amber — On
Enclosure-level fault condition exists. The event has been acknowledged but the
problem needs attention.
Off — No fault condition exists.
Green — On
The enclosure is powered on with at least one power supply operating normally.
Off — Both power supplies are off; the system is powered off.
Green — On
The enclosure temperature is normal.
Amber — On
The enclosure temperature is above threshold.
Figure 32 LEDs: 2U12 enclosure front panel
1
5
10
9
Disk drive LEDs on page 74.
Disk drive LEDs on page 74.
Enclosure bezel attachment
2
3
6
7
11
4
4
5 5
6 OK 6
7
7
(Silk screens on bezel)
on page 69 and
RPC24-694xx Series Setup Guide
Right ear
Figure 29
73