Specifications - Sony VPL-MX20 Quick Reference Manual

Specifications

Projection system
3 LCD panels, 1 lens, projection
system
LCD panel 0.63-inch XGA panel,
approximately 2,360,000 pixels
(786,432 pixels × 3)
Lens 1.2 times zoom lens (powered)
f 18.19 to 21.87 mm/F1.65 to 1.8
Lamp 200 W Ultra High Pressure
mercury lamp
Projected picture size (measured diagonally)
30 to 150 inches
30 to 150 inches (auto focus
operation range)
Light output 2500 lumen
(When the Lamp Mode is set to
"High.")
Throwing distance (When placed on the floor.)
30-inch: 0.86 to 0.99 m
(2.8 to 3.2 feet)
40-inch: 1.2 to 1.3 m
(3.9 to 4.3 feet)
60-inch: 1.8 to 2.0 m
(5.9 to 6.6 feet)
80-inch: 2.4 to 2.7 m
(7.9 to 8.9 feet)
100-inch: 3.0 to 3.4 m
(9.8 to 11.2 feet)
120-inch: 3.6 to 4.1 m
(11.8 to 13.5 feet)
150-inch: 4.5 to 5.1 m
(14.8 to 16.7 feet)
There may be a slight difference between the
actual value and the design value shown above.
Color system NTSC
3.58
NTSC
PAL60 system, switched
automatically/manually
(NTSC
when playing back a video
recorded in NTSC on a
NTSC
Resolution 750 horizontal TV lines (Video
input)
1,024 × 768 dots (RGB input)
Acceptable computer signals
fH: 19 to 80 kHz
fV: 48 to 92 Hz
(Maximum input signal resolution:
SXGA+ 1400 × 1050
fV: 60 Hz)
1)
Set the resolution and the frequency of the
signal of the connected computer within the
16
GB
Specifications
/PAL/SECAM/
/PAL-M/PAL-N/
4.43
is the color system used
4.43
system VCR.)
4.43
1)
range of acceptable preset signals of the
projector.
Applicable video signals
15 k RGB/Component 50/60 Hz,
Progressive component 50/60
Hz, DTV (480/60I, 575/50I,
480/60P, 575/50P, 720/60P, 720/
50P, 1080/60I, 1080/50I),
Composite video
273 × 45 × 206 mm (10
Dimensions
13 × 8
1 /
16
(without projecting parts)
Mass Approx. 1.7 kg (3 lb 12 oz)
Power requirements
AC 100 to 240 V, 2.9 to 1.2 A, 50/
60 Hz
Power consumption
VPL-MX25: Max 290 W
in standby (Standard): 11 W
in standby (Low): 2 W
VPL-MX20: Max 290 W
in standby (Standard): 6 W
in standby (Low): 2 W
Supplied accessories
Remote Commander (1)
Lithium battery CR2025 (1)
HD D-sub 15 pin cable (2 m) (1)
(1-791-992-51/Sony)
Carrying case (1)
AC power cord (1)
Operating Instructions (CD-ROM)
(1)
Quick Reference Manual (1)
Safety Regulations (1)
Security Label (1)
Design and specifications of the unit, including
the optional accessories, are subject to change
without notice.
Note
Always verify that the unit is operating properly
before use. SONY WILL NOT BE LIABLE FOR
DAMAGES OF ANY KIND INCLUDING, BUT
NOT LIMITED TO, COMPENSATION OR
REIMBURSEMENT ON ACCOUNT OF THE
LOSS OF PRESENT OR PROSPECTIVE
PROFITS DUE TO FAILURE OF THIS UNIT,
EITHER DURING THE WARRANTY PERIOD
OR AFTER EXPIRATION OF THE
WARRANTY, OR FOR ANY OTHER REASON
WHATSOEVER.
Optional accessories
Projector Lamp
LMP-M200 (for replacement)
Not all optional accessories are available in
all countries and area.
3
/ ×
4
1
/ inches) (w/h/d)
8