Table of Contents
Advertisement
Section 4
These instructions are provided as a guide for the removal
of the gear motor. Depending on the model number of your
dispenser, these instructions may vary slightly.
1. Disconnect power from the electric receptacle.
2. Remove all ice from the ice storage bin of the dispenser.
3. Remove the paddle wheel pin from the paddle wheel
agitator assembly inside the dispenser bin.
Removable Front
Merchandiser Panel
Beverage Valve
Part Number 020009324
(Option)
Water
Line
4. Remove the agitator assembly from the dispenser bin
by pushing the agitator to the back of the bin. Angle
the front of the agitator to the side. Pull the agitator
forward then out of the dispenser.
5. Remove the paddle wheel from the dispenser by
pulling the hub of the paddle wheel to the back of the
bin and off the gear motor shaft.
6. Remove the splash panel from the dispenser and
expose the gear motor.
7. Disconnect the electric connector from the gear motor
wire leads.
8. Remove the pin in front of the gear motor.
9. You must be able to remove the gear motor from the
dispenser.
10. To install a replacement gear motor, reverse this
procedure.
Gear
Drain
Motor
Pan
Agitator
Ice
Bin
Ice
Paddle
Wheel
Rocking Chute
Ice Dispense
Chute
Maintenance
21
Advertisement
Table of Contents
