Stacking The Appliance - LG DF22 V2BR Series Owner's Manual

INSTALLATION
24
2
Press the adapter duct
housing and secure it to the base of the
appliance as shown.
c
3
Insert the 10.2 cm elbow
opening and press it onto the adapter duct. Be
sure that the male end of the elbow faces down
through the hole in the bottom of the
appliance. Secure it in place with duct tape.
Attach the cover plate
appliance with the included screw.
e
d

Stacking the Appliance

Tools Required
• Phillips screwdriver
Stacking Kit Installation
WARNING
• The weight of the appliance and the height of
installation make this stacking procedure too
risky for one person. Two or more people are
required when installing the stacking kit.
• Place the washer on a solid, stable, level floor
capable of supporting the weight of both
appliances.
• Do not stack the washer on top of the dryer.
onto the blower
c
through the rear
d
to the back of the
e
• If appliances are already installed, disconnect
them from all power, water and drain
connections.
This stacking kit includes:
• Two (2) side rails
• One (1) front rail
• Four (4) screws
To ensure safe and secure installation, please
observe the following instructions.
1
Make sure the surface of the washer is clean
and dry. Remove paper backing from the tape
on one of the stacking kit side brackets.
2
Fit the side bracket to the side of the washer
top as shown. Firmly press the adhesive area of
the bracket to the washer surface. Secure the
side bracket to the washer with a screw on the
back side of the bracket. Repeat steps 1 and 2
to attach the other side bracket.
3
Place the appliance on top of the washer,
fitting the dryer feet into the side brackets as
illustrated. Avoid finger injuries; do not allow
fingers to be pinched between the washer and