Adexa C8A User Manual

Ⅰ. Structure of machine
1. Feeding stick 2. Meat pan
5. Handle 6. Switch
Meat Grinder Head
1.round screw cap 2.round blade
5.screw 6.grinding head
3.Lock handle 4.Grinder Head
3.knife 4.screw bolt
Ⅱ.Technical Data:
Model C8A
Efficiency 80kg/h
Power 370w
Voltage 230V
Packing size 360x210x410 mm
N.W 18kg
Ⅲ. Use and Maintenance:
1. Check the power, make sure the power is accordance with the
rated voltage and the plug is equipped with a ground line. As to
single-phase motor, the actual voltage should be more or less 10%
of the rated voltage, or it must be equipped with regulator,
connect the power and correct the direction before using it.
2. Before operation, take apart all the parts of the head, clean it one
by one, then assemble the head again and tighten the handle.
Attention that the front nut should not be too tight.
3. Weed the skin and bone before grind the meat, then cut it into
slice.
4. Switch on, put the raw meat into the filler after the motor in
normal condition. Press the raw meat with a stick when it's
necessary.
5. Check the machine as follows if the meat moves very slow or the
meat become mushily:
a. The carving knife fixed the board improper because of the front
nut too looseness, adjust the knife.
b. Dredge the outlet of the meat board when it is blocked.
c. The meat knife becomes blunt, mill it or change a new one.
6. Keep the machine clean, wash the grinding parts after using.
7. The damaged wire should be sent to the appointed agent or
serving spot if the wire is damaged. Or our company will not bear
the responsibility.
C12A C22A
120kg/h 220kg/h
750w 1100w
230V 230V
430x230x415 mm 460x230x435 mm
22kg 27kg