Page 1
MEAT GRINDER Model: MGW-180 INSTRUCTION MANUAL Before operating your meat grinder, please read all instructions carefully and keep for future reference. After-sales Service Email: service@adexa.co.uk...
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed the followings as below: 1. READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE. Failure to follow instructions may result in serious injury or property damage. 2. The warnings, cautions, and instructions in this manual cannot cover all possible conditions or situations that could occur.
12. Stay alert, watch what you are doing. Do not use the meat grinder while you are tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating the meat grinder may result in serious personal injury. SPECIFIC OPERATIONS WARNINGS 1.
Page 5
10. Thoroughly clean the parts that will come into contact with food before you use the appliance for the first time. 11. Do not leave the grinder running unattended. 12. Never operate the grinder without the Food Tray in place. Avoid contact with moving parts.
27. Do not fix the cutting blade or cutting plate when using the kubbe attachment. 28. If circuit breaker activates, Do not switch on. 29. Idling time should NOT exceed 2 minutes. Friction between moving parts may cause the parts wear and the engine overheat 30.
Page 7
PURPOSE NOTE: Some metal parts are coated with colorless and odourless FOOD GRADE MINERAL OIL. Oil could keep your grinder well lubricated and prevent rust from forming during storage. That’s why it’s important to coat meat grinder part with a small layer of oil.
Before assembling the Grinder: 1. Inspect the package carefully upon receipt. If there are signs of damage to the packaging, carefully check contents to ensure there are no missing or damaged parts. 2. We suggest you save all the packing material if future shipping of the machine is needed.
Page 10
Note: If it is NOT fitted properly, meat will NOT be ground and the Cutting Plate may be permanently damaged. Correct/Incorrect Cutting Blade Assembly 6. Place Cutting Plate. Position the desired Cutting Plate onto the Feed Screw against the flat sides of the Cutting Blade. Ensure the notches of the Cutting Plate fit into the slots of the Grinder Head tube.
without the Food Tray installed. 5. Use meat pusher. When mincing the meat, you can only use the food pusher stick to push the meat into the head.(FIG.11) Sausage Stuffing Assembly: 1. Attach grinder head to motor and install Feed Screw, Cutting Blade and Cutting Plate as described above in General Assembly.(FIG.12) 2.
Page 12
「OFF」 to shut down the appliance for at least 3 seconds. Press the Reverse switch and then turn the grinder ON again. If the grinder get jammed again, you may need to switch it off, unplug, disassemble the grinder head and clean the internal parts. 7.
CLEANING & MAINTENANCE CLEANING Always be as thorough as possible when cleaning and sanitizing components. Any part exposed to raw meat may harbor or develop bacteria, potentially causing illness or death. Please follow the cleaning steps for your health. 1. Clean appliance after each use and start cleaning immediately after use. Expect meat to leave oil and grease behind as it passes through your grinder (as well as stray bits of meat).
Page 14
6. Wipe down the outside of the Motor Housing with a damp cloth and then a fresh one to dry it. Warning: Never use abrasive cleaning agents or abrasive cloths when cleaning the unit. 7. Scrub the parts. Use a sponge to clean the Screw, cover, and Cutting Blade. Be careful when handling the blade, since this is sharp and can easily cut you if mishandled.
LIMITED WARRANTY Warranty period of the Electric Meat Grinder is 1 year. During the warranty period, the damage caused by non-human factors, we will be responsible for the free repair or replacement. Damages caused by other factors or after the warranty period, we will continue to provide services with reasonable price to the customer.