Download Print this page
Coleman 2000010698 Setup Instructions
Coleman 2000010698 Setup Instructions

Coleman 2000010698 Setup Instructions

Advertisement

Available languages

Available languages

Quick Links

Before you begin
• Read all instructions before set up.
• Select a level site clear of rocks, branches, and other hard or
sharp objects, to install your tent.
WARNING: Keep clear of overhead power lines.
• Do not set up your tent under trees because of potential
lightning strikes or falling tree limbs in inclement weather.
• Secure with all stakes and guylines provided to prevent
property damage or personal injury.
• For best results in windy conditions, position narrow end of
tent into the wind.
• Enlist the help of at least one other person to assist you
when it is time to assemble the tent.
Pole Descriptions
No.
Description
1
Main Body Pole, black, longest, thick
Front Pole, grey, thick
2
3
Side Pole, black, long, thin
4
Vestibule Pole, black, short, thin
1
Layout & Positioning
of Tent and Poles
• Layout and position the tent with door facing desired
direction. (Fig. 1)
• Stake down tent corners first through the stake rings. (Fig. 2)
• Keep the floor taut.
• Stake down the remainder of the stake rings.
• Assemble all poles by unfolding and interlocking the shock-
corded pole sections.
• Insert the body poles into the pole sleeves.
1
2
3
Fig. 1
Tent
Stake
Stake Ring
Fig. 2
TENT SETUP INSTRUCTIONS
Qty.
Pole
Pole
Repair Kit
Replacement Kit
2
5010000540
5010000548
1
5010000540
5010000548
2
5010000541
5010000547
1
5010000541
5010000547
1
3
Pole
Sleeve
MODEL 2000010698
2
Connect Poles to Tent
• Insert one pin into one end of the pole. (Fig. 3 and 4)
• Go to opposite end of pole and carefully insert the pin into the
other pole end. (Fig. 4)
• Repeat for all poles.
Fig. 3
Pole
Pin
Fig. 4
3
Attach Tent to Body Poles
Using Clips
• Attach clips along the edges of tent to body poles. (Fig. 5)
• Make any adjustments to the tent stakes, if needed.
4
Attach Rainfly
• Insert vestibule pole into pole sleeve located on underside of
rainfly. (Fig. 6)
• Drape rainfly over tent. (Fig. 7)
• Insert two pins into the vestibule pole ends respectively. (Fig. 8)
• Connect the elastic loops with "S" hooks, (found at the rainfly
corners) to the rings found at the tent corners. (Fig. 9)
• Secure rainfly with straps located on the underside of
rainfly. (Fig. 10)
• Attach and stake out guylines. (Fig. 7)
HINT: During setup, keep door zipped to keep proper tension
on fabric.
Pole
Clip
Fig. 5
(continued on other side)

Advertisement

loading
Need help?

Need help?

Do you have a question about the 2000010698 and is the answer not in the manual?

Questions and answers

Summary of Contents for Coleman 2000010698

  • Page 1 TENT SETUP INSTRUCTIONS MODEL 2000010698 Connect Poles to Tent Before you begin • Read all instructions before set up. • Select a level site clear of rocks, branches, and other hard or sharp objects, to install your tent. • Insert one pin into one end of the pole. (Fig. 3 and 4) WARNING: Keep clear of overhead power lines. • Go to opposite end of pole and carefully insert the pin into the • Do not set up your tent under trees because of potential other pole end. (Fig. 4) lightning strikes or falling tree limbs in inclement weather. • Repeat for all poles. • Secure with all stakes and guylines provided to prevent property damage or personal injury. • For best results in windy conditions, position narrow end of tent into the wind.
  • Page 2 • Tree limbs, tree sap, bird droppings, or moisture steadily dripping off tree limbs can cause damage to the tent fabric and its coating resulting in leaks or loss of flame-resistant properties. • Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A. 1-800-835-3278 in the United States • www.coleman.com poles inside your tent. Use a separate storage bag. Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions • Stakes should be removed by pulling on the stake itself. NEVER 20B Hereford Street • Brampton, ON L6Y 0M1 PULL ON THE TENT TO REMOVE STAKES AS THIS COULD RESULT 1-800-387-6161 in Canada • www.coleman.com IN PROPERTY DAMAGE OR PERSONAL INJURY. MADE IN BANGLADESH • Tent poles should not be left telescoped together during storage. © 2011 The Coleman Company, Inc. All rights reserved. • Do not leave your tent set-up for weeks at a time. Be aware that Coleman , and are registered trademarks of The Coleman Company, Inc. ® exposure to ultraviolet rays from the sun can seriously damage 4010017210 (ECN20020549-01) material and/or cause it to become discolored.
  • Page 3 INSTRUCTIONS DE MONTAGE DE LA TENTE MODÈLE 2000010698 Accrochage des mâts Avant de commencer • Lisez toutes les instructions avant d’entreprendre le montage. à la tente • Choisissez l’emplacement où vous monterez votre tente: plat, sans pierres, branches ou autres objets pointus. • Insérez une goupille dans un bout du mât. (Fig. 3 et 4) AVERTISSEMENT: Éloignez la tente des lignes électriques • Allez au bout opposé du mât et, avec beaucoup de précautions, aériennes. introduisez la goupille dans cet autre bout de mât. (Fig. 4) • Ne montez pas la tente sous les arbres afin d’éviter les risques • Agissez ainsi avec tous les mâts. de foudroiement ou de branches qui tombent par gros temps.
  • Page 4 TOUTE FLAMME ET DE TOUTE SOURCE DE CHALEUR. vêtements mouillés laissés dans la tente. Il ne s’agit ABSOLUMENT Cette tente est conforme à la norme d’inflammabilité CPAI-84. Cette PAS d’humidité ayant pénétré la toile. Vous pouvez minimiser la tente est fabriquée d’un tissu résistant au feu, mais qui n’est pas condensation en gardant les vêtements mouillés hors de la tente ininflammable. Ce tissu brûlera s’il est laissé en contact continu avec et en maintenant une bonne ventilation en tout temps. une source d’inflammation. Appliquer toute substance étrangère sur • Les branches, la sève, les excréments d’oiseaux ou l’humidité le tissu peut neutraliser les propriétés de résistance aux flammes. dégouttant constamment des branches peuvent abîmer la toile et son revêtement et provoquer suintement ou perte des propriétés de résistance aux flammes. • Ne rangez jamais la tente, même temporairement, sans la faire The Coleman Company, Inc. • 3600 North Hydraulic • Wichita, Kansas 67219 U.S.A. 1-800-835-3278 aux États-Unis • www.coleman.com totalement sécher au préalable et sans brosser la terre qui y Sunbeam Corporation (Canada) Limited • DBA Jarden Consumer Solutions adhère. Ne roulez jamais les piquets ou les mâts à l’intérieur de la 20B Hereford Street • Brampton, ON L6Y 0M1 tente, utilisez un sac distinct. 1-800-387-6161 au Canada • www.coleman.com • Tirez sur les piquets pour les déterrer. NE TIREZ SURTOUT JAMAIS FABRIQUÉE AU BANGLADESH SUR LA TOILE POUR DÉTERRER LES PIQUETS – VOUS POURRIEZ © 2011 The Coleman Company, Inc. Tous droits réservés. CAUSER DOMMAGES MATÉRIELS ET BLESSURES CORPORELLES. Coleman ® , et sont des marques déposées de The Coleman Company, Inc. • Ne rangez pas la tente avec ses mâts emboîtés, déboîtez-les. 4010017210 (ECN20020549-01)