Table of Contents
Advertisement
Quick Links
4" Angle Grinder
• Built-in regulator to control speed.
• Planetary gearing balances load on bearings and gears for greater power.
• Side exhaust.
• Recommended air pressure 90 psi.
Part Number
AP7319
Sanding
Free
Pad
Speed
Inch
Met
RPM
(")
(mm)
4
100
10,000
Air
Air
Average Air
Inlet
Hose
Consumption
ID
cfm
1/4"
3/8"
5
Net Weight
l/min
lbs
Kg
140
2.86
1.3
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aeropro AP7319
Summary of Contents for Aeropro AP7319
- Page 1 • Planetary gearing balances load on bearings and gears for greater power. • Side exhaust. • Recommended air pressure 90 psi. Sanding Average Air Free Net Weight Inlet Hose Consumption Part Number Speed Inch l/min (“) (mm) AP7319 10,000 1/4” 3/8” 2.86...
-
Page 2: Air Supply
Operating Instructions Description Rugged die-cast aluminum body for durability. Ergonomic rubber grip for comfortable use. Built-in regulator for positive speed control. Screened inlet to prevent dirt particles from entering air intake. Ideal for smoothing concrete, removing burrs from metal and for finishing weld seems. Side exhaust. -
Page 3: Loading And Operation
Operating Instructions In the event that it becomes necessary to store the tool for an extended period of time (overnight, weekend, etc.) lubricate the tool generously. The tool should be run for approximately 30 seconds to ensure that the oil has been evenly distributed throughout the tool. The tool should be stored in a clean and dry environment. -
Page 4: Troubleshooting
Operating Instructions Trouble Shooting The following table details the common operating system with problem and solutions. Please read the table carefully and follow it. WARNING: If any of the following symptoms appear during your operating, stop using the tool immediately, or serious personal injury could result. Only qualified persons or an authorised service centre can perform repairs or replacement of tool. -
Page 5: Residual Risks
Safety Rules and Hazards Residual Risks Even when the tool is used as prescribed it is not possible to eliminate all residual risk factors. The following hazards may arise in connection with the tool’s construction and design: 1. Damage to lungs if an effective dust mask is not worn. 2. -
Page 6: Projectile Hazards
Safety Rules and Hazards General Safety Rules 1. For multiple hazards, read and understand the safety instructions before installing, operating, repairing, maintaining, changing accessories on, or working near the power tool. Failure to do so can result in serious bodily injury. 2. -
Page 7: Operating Hazards
Safety Rules and Hazards Operating Hazards 1. The use of the tool can expose the operators hands to hazards including crushing, impacts, cuts, abrasions and heat. Wear suitable gloves to protect hands. 2. Operators and maintenance personnel shall be physically able to handle the bulk, weight and power of the tool. -
Page 8: Dust And Fume Hazards
Safety Rules and Hazards Dust and Fume Hazards 1. Dust and fumes generated when using power tools can cause ill health (for example, cancer, birth defects, asthma or dermatitis); risk assessment and implementation of appropriate controls for these hazards is essential. 2. -
Page 9: Vibration Hazards
Safety Rules and Hazards Vibration Hazards 1. Exposure to vibration can cause disabling damage to the nerves and blood supply of the hands and arms. 2. Keep the hands away from the nutrunner sockets. 3. Wear warm clothing when working in cold conditions and keep your hands warm and dry. 4.
Need help?
Do you have a question about the AP7319 and is the answer not in the manual?
Questions and answers