Cuisinart AMW-60HK Instruction And Recipe Booklet page 5

50. The instructions shall state that appliances are not intended to be
operated by means of an external timer or separate remote-control
system.
51. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
SAVE THESE INSTRUCTIONS.
FOR HOUSEHOLD USE ONLY.
PRECAUTIONS TO AVOID POSSIBLE
EXPOSURE TO EXCESSIVE
MICROWAVE ENERGY
1. Do not attempt to operate this oven with the door open, as this can
result in harmful exposure to microwave energy. It is important not to
break or tamper with the safety interlocks.
2. Do not place any object between the oven front face and the door or
allow soil or cleaner residue to accumulate on sealing surfaces.
3. Do not operate the oven if it is damaged. It is particularly important
that the oven door closes properly and that there is no damage to the
door (for example, make sure that it is not bent); hinges and latches
(for example, make sure that they are not broken or loosened); door
seals and sealing surface.
THE OVEN SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE
EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL. IF THE
MICROWAVE UNIT IS NOT KEPT CLEAN, ITS SURFACE COULD BE
DEGRADED AND LEAD TO A HAZARDOUS SITUATION.
PRECAUTIONS TO BE OBSERVED BEFORE AND DURING
SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE
MICROWAVE ENERGY
(a) Do not operate or allow the oven to be operated with the door open.
(b) Make the following safety checks on all ovens to be serviced before
activating the magnetron or other microwave source, and make repairs
as necessary: (1) interlock operation, (2) proper door closing, (3) seal and
sealing surfaces (arcing, wear, and other damage), (4) damage to or loos-
ening of hinges and latches, (5) evidence of dropping or abuse.
(c) Before turning on microwave power for any service test or inspection
within the microwave generating compartments, check the magnetron,
wave guide or transmission line, and cavity for proper alignment, integri-
ty, and connection.
(d) Any defective or misadjusted components in the interlock, monitor,
door seal, and microwave generation and transmission systems shall be
repaired, replaced, or adjusted by procedures described in this manual
before the oven is released to the owner.
(e) A microwave leakage check to verify compliance with the Federal
Performance Standard should be performed on each oven prior to
release to the owner.
4