Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Spectrum FLEDSCOUT EC 110 Meter
Summary of Contents for Spectrum FLEDSCOUT EC 110 Meter
- Page 1 ® EC 110 Meter DATA LOGGER MANUAL Item # 2220...
-
Page 2: Table Of Contents
EC 110 meter. Please read this manual thoroughly before using your instrument. For customer support, or to place an order, call Spectrum Technologies, Inc. (800)248-8873 or (815) 436-4440 between 7:30 am and 5:30 p.m. CST, FAX (815)436-4460, e-mail: specmeters.com. -
Page 3: General Overview
General Overview Thank you for purchasing the data logging EC 110 meter from Spectrum Technologies, Inc. This user’s guide deals with the features that are unique to the data logging EC 110 meter. Infor- mation on general meter operation is contained in the accompanying Instruction manual. -
Page 4: Data Logger Operation
Data Logger Operation The data logger has two modes of operation: Com- munication and Measurement. These modes are indicated by the green LED in the lower left corner of the meter. When this light is flashing, the meter is in Communication mode. - Page 5 Taking and Data Logging Measurements When the probe is inserted in soil or water, the me- ter’s LCD will immediately begin indicating the EC. When this value stabilizes, the meter locks on to that value and the LCD will display READY in the upper right corner.
-
Page 6: Identifying The Correct Com Port
Identifying the Correct Com Port T h e c o m p u t e r Communications Port to which cable connected identified by using a paper clip. 1. Disconnect the serial cable from the meter. 2. To bring up the Port Selection screen, click on the Com Port Button, select the com port to be tested and click the Port Test button. -
Page 7: Connecting To A Pc
Connecting to a PC The EC 110 Meter software comes with a black PC inter- face cable. This cable connects to the USB port of your computer and to the meter’s computer port. The meter’s configuration can be modified by clicking on the Meter Settings button (see Meter Settings, p. -
Page 8: Logger Software
Logger Software Meter Type The Field Scout software supports all of Spectrum Technologies’ portable data logging meters. Be sure to select the EC 110 Meter from the Se- lect Meter Type screen Meter Settings Clicking on this button will bring up the Meter Set- tings screen. - Page 9 Download After clicking Download button, a progress bar will con- firm that data is being extracted from the log- ger. When com- pleted, the Save Data As box will appear. From here you can give the data file a descriptive name and select a folder in which to save it.
-
Page 10: Data Files
Data Files Sample data showing results of data collected with and without GPS activated. Note: GPS signal not found when recording data in lines 12 through 14. The data is stored in comma-delimited text files. These files can be opened with text-editing software (e.g. Micro- Soft Word) or spreadsheet software (e.g. -
Page 11: Gps Connection
GPS signal, check that it has the following set- tings: Data bits: 8 Stop bits: 1 Baud rate: 4800 bps Parity: None Timing: 1 second GGA data string SPAD EC110 Meter Meter Unit Spectrum GPS computer GPS/DGPS interface cable Cable... - Page 12 Initial GPS connect If the meter does NOT detect an incoming GPS signal, it will flash steadily for 10 seconds and then glow steadily once it gets into Measurement mode. If it does detect the GPS signal (satellites found etc..), it gives a series of 3 rapid flashes before going to the steady glow for Measurement mode.
-
Page 13: Direct-Insert Probe
Direct- Insert Probe Figure 1. Orientation of pins on probe/meter interface Connecting the Probe The female connector for the direct-insert probe pushes straight onto the 6-pin male socket on the digital reader (see fig. 1). When inserting the probe, rotate the plug to align the notch on the probe with the guide on the inner wall of the socket. -
Page 14: Service And Support
Who do I contact? Contact the company that you bought the loggers from: Spectrum Technologies, Inc. or a Spectrum Authorized Dealer. Before calling, you can evaluate and often solve your problem if you try the following. -
Page 15: Specifications
This product is warranted to be free from defects in material or workmanship for one year from the date of purchase. During the warranty period Spectrum will, at its option, either repair or replace products that prove to be defective. This warranty does... - Page 16 This equipment has been manufactured for Spectrum Technologies, Inc. 3600 Thayer Court Aurora, IL 60504 USA The Manufacturer’s DECLARATION OF CONFORMITY is on file at the above address, and certifies conformity to the following: Model Number: 2220 Description: Data Logging Electrical Conductivity Meter...