Table of Contents
Advertisement
-
With the + and - button is possible to select the desired
brightness (three brightness levels available).
-
After 5 seconds without to press any button, the
brightness level will be memorized and the operating
conditions will be the same ones previously set.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
-
(Probe Failure) blinking
With this alarm the appliance does not operate. Contact
the De'Longhi Customer Service.
-
(High temperature)
When the product's internal temperature is too high,
the heating power will progressively and automatically
be reduced.
The display shows
remove the cause of this alarm check that the unit is not
covered and let the appliance cool down.
TROUBLESHOOTING
PROBLEM
The display doesn't work
The appliance doesn't warm up
The display shows:
The display shows:
(High temperature) blinking
for two seconds, blinking. To
Be sure it is plugged in and that the
electrical outlet is working
The safety device may have switched off
the appliance
The temperature may be set too low
It indicates that the room temperature
blinking
sensor has failed
The unit has reached a too high internal
temperature
SAFETY DEVICE
A safety device switches the heater off in the event of
overheating.
To restart the heater, call the De'Longhi Customer Service.
MAINTENANCE
Always remove the plug from the power outlet and allow the
radiator to cool. Wipe radiator with a soft damp cloth, do not
use detergents and abrasives. Should the radiator not be in
use over a certain length of time, wind the cord around the
cord holder and store it in a dry place. This appliance has been
built to give many years of trouble free service.
In case of malfunction or doubt, do not try to repair the heater
by yourself: this may result in a fire hazard or electric shock.
Call the De'Longhi Customer Service (see attached list of
De'Longhi Customer Service).
TECHNICAL CHARACTERISTICS
Supply voltage
Absorbed power
CAUSE
12
See rating plate
SOLUTION
Plug into the power outlet
Remove the obstruction and let the
appliance cool down. If the appliance
doesn't work please contact the De'Longhi
Customer Service
Set the temperature to a higher value
Please contact the De'Longhi Customer
Service
Check that the unit is not covered and let
the appliance cool down. When the product
internal temperature decreases, the alarm
will disappear.
If the appliance doesn't work please contact
the De'Longhi Customer Service
"
Advertisement
Table of Contents
