Wired Network Settings - Grundig 43 VLX 7710 BP User Instructions

NETWORK­SETUP
Wired­network­settings
There are two ways of making the wired net-
work settings.
A Automatic connection,
A ll data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) are obtained from modem auto-
matically.
B Manual connection,
a ll data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) must be configured manually.
Automatic­connection
Most of the home networks are Dynamic. If
you have a dynamic network, you must use a
DSL modem that supports DHCP. Modems and
IP sharers that support DHCP obtain the »IP
Address«, »Netmask«, »Gateway« and »DNS«
values required for internet access automatical-
ly, and thus you are not required to enter those
values manually.
1­
Open the menu with »MENU«.
2­ Select menu item »Settings« with »
< >
» « or » « and press »OK« to confirm.
3­
Select the menu item »Network« with »
<
» « and press »
– » Network« menu is active.
Settings > Network
Picture Sound Source
Change Connection Type
Network Configuration
Wake-on-LAN
Advanced
Connect Test Connection Change Area
4­ Select the line »Change Connection Type«
» « or » « and press »OK« to confirm.
V Λ
5­
Select the option »Wired« with »
and press »OK« to confirm.
82­ ENGLISH
­ - ------------------------------------------------------------------------------------------
«, »
V
« to confirm.
V
Tuesday
xx xxx xxxx
TV Network Timer Parental
Wired
AUTO
Off
Select
« or »
V
6­ Select the line »Network Configuration«
with »
V
select »AUTO«.
7­
With »

modem connection.
– » Connecting ... Please wait« message
will be displayed, and if the connection
is established »Connection To Gateway:
Success« message will be displayed.
8­ Press »

settings and also if the local network and
internet connection has been established.
– » Testing ... Please wait« message will
be displayed, and if the connection is
established »Connection To Gateway:
Success«, »Internet Connection: Success«
message will be displayed.
9­ Press »EXIT« to end the settings.
Note:
If you do not have a dynamic network,
7
follow the instructions in manual connection
section.
«,
Λ
>
« or
Zurück
BACK
«
Λ
<
« or » « and use »
Λ
« (red) select »Connect« to establish
« (green) to check the performed
>
« or » « to