Table of Contents
Advertisement
NOTE!
Remember to press the Start/Stop button to start the program.
START THE DISHWASHER
Press and hold Start/Stop until the display shows
open symbol). This indicates that the dishwasher is ready to start.
Close the door properly, otherwise the dishwasher will not start.
NOTE!
If the machine does not start within 2 minutes of the last button
press, the display returns to showing the last program run.
TIME REMAINING
Once you have selected a program and options, the display
indicates how long the program took the last time it was used. The
remaining time is updated after the water for the final rinse has
been heated.
This may differ somewhat from time to time depending on the
temperature of the water supply, the amount of dishes, the
ambient temperature and other factors.
NOTE!
During the first run of each program, the remaining time
displayed can be slightly misleading, as the dishwasher is estimating
the time. When you run the program a second time, the
dishwasher will calculate the remaining time based on the
previous duration of the program.
8
STOPPING OR CHANGING A PROGRAM
If you want to change program after starting the dishwasher, open
the door then press and hold Start/Stop for three seconds. Add
more detergent if the lid of the detergent dispenser has opened.
Then choose a new program, press Start/Stop and close the door.
(the door
DO YOU WANT TO ADD MORE DISHES?
Open the door. The dishwasher stops automatically. Add the
dishes, close the door and the dishwasher continues the program.
IF THE DISHWASHER IS TURNED OFF USING
THE ON/LEFT-ON MODE BUTTON OR DUE TO
A POWER FAILURE
If the dishwashing program was not finished, the interrupted
program continues when power is restored.
NOTE!
During drying, the program is interrupted if the power is cut or
the door is open for more than 2 minutes.
ONCE THE PROGRAM HAS FINISHED
Once the program has finished and the door is opened "End"
appears on the display.
A buzzer also sounds at the end of the program. See the section
Settings, which describes how to change this function.
Once the dishwasher has finished, it uses only standby power. Turn
off the water supply valve after each use.
Drying
For additional drying the door should be opened 35 mm upon
completion of the drying cycle. For more information, see page
16 in the chapter Technical information.
Advertisement
Table of Contents
