Dell E43S001 Reference Manual page 24

Option Description
Redundant OS
Boot
When set to Enabled, BIOS boots to the device specified in Redundant OS Location. When set to
Disabled, BIOS preserves the current boot list settings. This option is set to Disabled by default.
Miscellaneous Settings
You can use the Miscellaneous Settings screen to perform specific functions such as updating the asset tag and changing the
system date and time.
Viewing Miscellaneous Settings
To view the Miscellaneous Settings screen, perform the following steps:
Steps
1. Power on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
3. On the System Setup Main Menu screen, click System BIOS.
4. On the System BIOS screen, click Miscellaneous Settings.
Miscellaneous Settings details
About this task
The Miscellaneous Settings screen details are explained as follows:
Option Description
System Time Enables you to set the time on the system.
System Date Enables you to set the date on the system.
Asset Tag Specifies the asset tag and enables you to modify it for security and tracking purposes.
Keyboard Enables you to set whether the system should boot with the NumLock enabled or disabled. This option is
NumLock set to On by default.
F1/F2 Prompt on Enables or disables the F1/F2 prompt on error. This option is set to Enabled by default. The F1/F2
Error prompt also includes keyboard errors.
Load Legacy Enables you to determine whether the system BIOS loads the legacy video (INT 10H) option ROM from
Video Option the video controller. Selecting Enabled in the operating system does not support UEFI video output
ROM standards. This field is available only for UEFI boot mode. You cannot set the option to Enabled if UEFI
Secure Boot mode is enabled. This option is set to Disabled by default.
Dell Wyse Enables or disables the Dell Wyse P25/P45 BIOS Access. This option is set to Enabled by default.
P25/P45 BIOS
Access
Power Cycle Enables or disables the Power Cycle Request. This option is set to None by default.
Request
24 Pre-operating system management applications
NOTE: This option is disabled if Redundant OS Location is set to None or if Redundant OS State
is set to Hidden.
NOTE: This option does not apply to 84-key keyboards.