Table of Contents
Advertisement
Safety Decals
Understanding safety decals and their
purpose assists in the safe operation of
your sprayer. Safety decals are there for
your protection and it is the responsibility
of the owner operator to replace damaged
and/or missing safety decals.
Regularly review safety decals with
operators. It is very important to ensure
that all new machine components and
replacement parts include current hazard
identification decals.
Replacement safety decals can be ordered
from all Goldacres dealers.
GA5064280
ONLY FOR USE WITH DIESEL FUEL
DO NOT USE FOR/WITH PETROL (GASOLINE)
SOLVENTS WITH FLASH POINT >55º
READ THE OPERATORS INSTRUCTION MANUAL BEFORE ATTACHING OR
USING THIS PRODUCT. REFER TO YOUR VEHICLE'S OPERATION MANUAL
FOR THE MAXIMUM LOAD LIMITS AND OPERATING PROCEDURES.
DO NOT EXCEED SPECIFIED SAFE LOAD CARRY AND TOWING CAPACITIES.
STABILITY OF THE VEHICLE CAN BE AFFECTED BY THE ATTACHMENTS
AND ALLOW GREATER DISTANCE FOR BREAKING.
FAILURE TO DO ANY OF THE ABOVE MAY RESULT
IN SERIOUS INJURY OR DEATH
OPERATION
Connections
The following steps should be followed when
connecting to a power source:
1. Ensure that the battery is 12V DC
2. Connect the red connector to the
positive (+) terminal and the black
connector to the negative (-) terminal.
Filling
When filling the diesel tank, it is necessary
to wear the appropriate PPE.
The following steps should be followed when
filling the tank:
1. Earth strap - prevent static build up
when filling by connecting the earth
strap to a common ground.
2. Remove the tank lid.
3. Add the amount of diesel as required.
4. Replace the tank lid and ensure that it is
secure prior to switching on the pump.
Transferring
When transferring diesel out of the transfer
tank, it is necessary to wear the appropriate
PPE.
The following steps should be followed when
transferring from the tank:
1. Prior to connecting the power leads,
ensure that the battery is 12V DC and
that the switch on the pump is turned
"off" (see photos).
2. Connect the red connector to the
positive (+) terminal and the black
connector to the negative (-) terminal of
a 12V battery.
3. Remove the lid of tank to be filled.
4. Insert the Auto shut off nozzle into the
tank to be filled.
5. Turn the switch to "on" on the 12V
pump.
6. Open the Auto shut off nozzle to allow
fuel to start transferring.
7. Suction Filter should be cleaned
periodicly to ensure proper operation.
GA5064275
100
100
Note: When the Auto shut off nozzle is
disengaged, the pump can continue to run.
Do not run the pump longer than three
minutes while not actually transferring
diesel.
General Information and
specifications
Tank: Diesel grade polyethylene - grey
Lid: Lockabble fuel cap & lockable
dispensing gun mount on 450L (cube) and
800L models. Lockable flip lid on 100,
200, 400 & 600L models.
Gun: Automatic shut off gun. Max flow 80
lt/min
Battery cable: Supplied with 4 metres of
cable with alligator clips
Delivery hose: Supplied with 4 metres x
20mm diesel delivery hose. Swaged fittings.
Filtration: Filter screen in suction head of
pump (refer to photo)
Earthing straps: Internal strap. External
cable with alligator clip.
Breather vent: Breather installed in tank lid.
8
Advertisement
Table of Contents
