How To Configure Site-To-Site Ipsec Vpn Where The Peer Has A Dynamic Ip Address; Set Up The Zywall/Usg Ipsec Vpn Tunnel Of Corporate Network (Hq) - ZyXEL Communications VPN Series Handbook

Security firewalls

Table of Contents

How to Configure Site-to-site IPSec VPN Where the Peer has a

Dynamic IP Address

This example shows how to use the VPN Setup Wizard to create a site-to-site VPN

with the Peer has a Dynamic IP Address. The example instructs how to configure

the VPN tunnel between each site. When the VPN tunnel is configured, each site

can be accessed securely.

ZyWALL Site-to-site IPSec VPN with a Dynamic IP Address Peer

Note: All network IP addresses and subnet masks are used as examples in this article.

Please replace them with your actual network IP addresses and subnet masks. This example

was tested using USG310 (Firmware Version: ZLD 4.25).

Set Up the ZyWALL/USG IPSec VPN Tunnel of Corporate Network

www.zyxel.com