Daily Use - AEG FAVORIT 88072 User Manual

30 www.aeg.com
6.3 Filling the rinse aid dispenser

7. DAILY USE

1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer
to 'SETTING AND STARTING A PRO-
GRAMME'.
• If the salt indicator is on, fill the salt
container.
7.1 Using the detergent
A
7.2 Setting and starting a
programme
Setting mode
The appliance must be in setting mode
to accept some operations.
A
A
+ -
B
30
A
20
-
+
C
1. Press the release button (D) to open
B
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
C
You can turn the selector of the
released quantity (B) between
D
position 1 (lowest quantity) and
position 4 (highest quantity).
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree
of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come
on.
• The display shows two horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press and hold Delay and Start at