Philips AWH1613/51 100YA User Manual page 14

RCD (residual current device)
• Prevention of electrical leakage
• Follow the installation instructions when
connecting the water heater
• Connect the power plug to the mains, press
the button on the front side of the RCD (3),
the indicator light will light up
• To test the RCD, press the TEST button (2)
The Power indicator (1) will be off.
• To restart the RCD, press button (3)
12
1 2
3
fig
5
Exploitation
Turning on the water heater
1 Open one of the hot water outlet valves,
then open the cold water supply valve The
electric water heater will begin to fill with
water. When water flows freely from the
hot water tap, this means that the water
heater is completely filled with water and
the hot water outlet tap can be closed
2 Insert the electrical plug into the socket
Power mode selection
To select the power mode, turn the switch
[1] and select one of the heater heating
power modes:
I - low (800 W)
II - medium (1200 W)
III - intensive (2000 W)
Attention!
During normal operation, the cold water
supply tap must be set to the «open»
position
1
1 Power mode switch
2 Temperature regulator
3 Heating indicator
4 Power indicator
3 4
OptimalTEMP
2
fig
6