Table of Contents
Advertisement
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an error
code and the Start/Pause button may flash continuously:
Error code
Appliance motor overloaded.
E50
Too much laundry or entrap in the drum.
Internal fail. No communication between
electronic elements of the appliance.
E90 or E91
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the problem
continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible solutions.
11.2 Troubleshooting
Problem
The tumble dryer is not connected to the
mains supply.
The door is open.
The tumble dryer
does not operate.
The On/Off button was not pushed.
The Start/Pause button was not touched.
The appliance is in standby mode.
24
ENGLISH
Possible cause
Possible cause
Remedy
The programme was not completed. Re‐
move the laundry from the drum, set the
programme and restart the cycle.
The programme was not finished properly
or the appliance stoped too early. Switch
the appliance off and on again.
If the error code appears again, contact the
Authorised Service Centre.
When the appliance is showing EH0, please
wait until main supply is stable than press
start. If the appliance pause the cycle with‐
out any indication then press the cycle start.
If the warning will occur check the power
cord / socket integrity or main supply.
Remedy
Connect it to the mains socket. Check the
fuse in the fuse box (domestic installation).
Close the door.
Push the On/Off button.
Touch the Start/Pause button.
Push the On/Off button.
Advertisement
Table of Contents
