Options - AEG TR834E94E User Manual

6. OPTIONS

6.1 Dryness Level
This option helps to achieve requested laundry dry‐
ness. You can select the level of dryness:
ready to iron - iron dry level
ready to store - cupboard dry lev‐
1)
el
ready to store - extra dry level
1)
Default selection which is related to the programme
6.2 Time Dry
For: Cottons, Bedlinen XL, Synthetics and
MixDry programs. Lets the user to set drying
time from minimum 10 min to maximum of 2
hours (in 10 min steps). When this option is
maximum, load indicator disappears.
The cycle lasts as long as set drying time
regardless of the size of a load and its
dryness.
TIME DRYING RECOMMENDATION
up 10 min action of cool air only (no heater).
10 - 40 additional drying to improve dryness af‐
min ter previous drying cycle.
full drying of the small laundry loads up
> 40 min
to 4 kg, well spun (>1200 rpm).
Time Dry on Wool program
Option applicable to Wool program to adjust
final dryness level to more dry or less dry.
6.3 + Anti Crease
Extends up to 120 minutes the anti-crease
phase (30 minutes) at the end of the drying
cycle. After drying phase drum rotates from
time to time to prevent creases. Laundry can
be removed during the anti-crease phase.
14 ENGLISH
6.4 Silent
The appliance operates with low noise
without effect on the drying quality. The
appliance operates slowly with longer cycle
time.
6.5 Refresh
To refresh clothes that were in storage.
Maximal load cannot exceed 1 kg.
6.6 Buzzer
The acoustic signal sounds at the following:
• cycle end
• start and end of crease guard phase
The acoustic signal is by default always on.
You can use this option to activate or
deactivate the sound.
Buzzer option off:
1. Turn the dryer on.
2. Select 1 of the available programs.
3. Touch and hold down Refresh button by
around 3 seconds.
The symbol appears on the display.
4. To activate the Buzzer, touch the above
button again until the symbol disappears.
6.7 Finish In
This option allows choosing the time at
which a programme should terminate.
Once activated the machine waits for the
right moment to begin the drying process.
Finish In time is the sum of stand by time and
drying time.
To set the Finish In option:
1. Set the drying programme and options.