Craftsman 247.985360 Operator's Manual page 9

4. Pivot flange keepers out and position the chute assembly over the
base. See Figure 3.
5. Close the flange keepers to secure the chute assembly to the
chute base. See Figure 4. The flange keepers will click into place
when properly secure.
NOTE: If the flange keepers will not easily click into place, use the
palm of your hand to apply swift, firm pressure to the back of each.
6. Remove the cap, flat washer, and hairpin clip from the end of
the chute directional control.
7. Insert the end of the chute directional control into the lower
bracket and secure with the flat washer and hairpin clip just
removed. See Figure 5. If necessary, the lower bracket can
be adjusted. Refer to Chute Bracket Adjustment in the
Service & Maintenance section.
ASSEMBLY
Figure 3
9
Figure 4
Figure 5