Table of Contents
Advertisement
Figure 48. Peel off the conductive tape
Step 4.
Lift up the camera board and microphone board. Then, detach the camera cable connector from
the microphone board.
Note: The camera board and microphone board are fragile and easily-bent. Take care when
removing the boards.
Figure 49. Remove the camera board and microphone board
Remove the hinges
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
"Remove the battery pack" on page 31
"Remove the upper case (with keyboard)" on page 48
"Remove the LCD panel" on page 49
Step 1.
Remove the 6 screws.
.
Chapter 4
Removing a FRU or CRU
53
Advertisement
Table of Contents
