Table of Contents
Advertisement
2nd
3rd
Input Port Ver.
Auto Source Switch+
Key Repeat Time
Power LED On
VRR Control
Setup Custom Key
Eco Sensor Mode
Description
Select an HDMI version.
•
1.4
/
2.0↑
― The supportable device and resolution may differ depending on its version.
― When the version is changed, the screen may blink.
― If you set the
HDMI Mode
to 1.4, some high resolutions may not be supported because of bandwidth limitation of the HDMI 1.4 protocol.
― When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device.
― Set
HDMI Mode
to
1.4
if the monitor is connected to an HDMI device and the monitor does not display the screen properly, displays a blank screen, or does
not play sound at all.
By activating, a new connected source is displayed automatically.
― This function may not be supported depending on the model or geographical area.
Control the response rate of a button when the button is pressed.
Acceleration,
1
sec, or
2 sec
can be selected. If
Configure the settings to enable or disable the power LED located at the lower part of the product.
•
Working: The power LED is on when the product is turned on.
•
Stand-by: The power LED is on when the product is turned off.
By optimizing the video signal processing, this additional function mitigates screen flicker.
While playing any game or content that causes screen flicker, use the
Set the custom key so that your chosen function can be set up directly.
•
Eye Saver Mode
/
PIP
/
Refresh Rate
/
Ultrawide Game View
Source Switch+
/
Picture Mode
/
Response Time
Optimizes brightness in real time, based on your lighting environment.
No Repeat
is selected, a command responds only once when a button is pressed.
VRR Control
function with setting it to On.
/
Low Input Lag
/
Black Equalizer
/
Virtual Aim Point
/
Infinity Core Lighting
/
Auto
36
Advertisement
Table of Contents
