Caster Wheels; Anti-Scalp Rollers; Tire Pressures; V-Belts - Husqvarna 967324002-00 Operator's Manual

MAINTENANCE

Caster Wheels

Check at 200 hour intervals. Check that wheels
turn freely. If wheels do not turn freely take the
unit to your dealer for service.
Foam filled tires or solid tires will void the
warranty.
Removal and installation
Remove nut and caster bolt. Pull the wheel out of
the yoke and take care of the spacers. Install in
reverse order. Tighten caster bolt.

Anti-scalp Rollers

Anti-scalp rollers are correctly adjusted when
they are slightly off of the ground when the deck
is at the desired cutting height in the operating
position. Anti-scalp rollers keep the deck in the
proper position to help prevent scalping in most
terrain conditions.
The anti-scalp rollers can be set in three
positions:
• Upper position 1-1/2" to 2-1/2" grass
• Middle position 2-1/2" to 4" grass
• Lower position 4" to 6" grass.
The rollers must be approximately 1/4" from the
ground.
24

Tire Pressures

All tires must be at 15 psi / 103 kPa / 1 bar.
IMPORTANT INFORMATION DO NOT add
a tire liner or foam fill material to the tires.
Excessive loads created by foam filled tires will
cause premature failures.
Only use O.E.M. specified tires.

V-belts

Check at 100 hour intervals of operation. Check
for severe cracking and large nicks.
NOTE: The belt will show some small cracks in
usual operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.
Deck Belt Removal
1. Park on a level surface. Apply park brake.
2. Lower the deck into the lowest cutting
position.
3. Remove bolts from belt shields and remove
shields.
4. Remove any dirt or grass that may have
accumulated around the cutter housings and
entire deck surface.
5. Loosen the nut securing the belt guide. Note
the position of the belt guide for reinstallation.