Leds - Biostar B760M-SILVER Manual

Note
» » Ensure proper pin connecting to your LED device, wrong connection may damage your LED device or
motherboard.
» » The 12V_LED connector supports to 5050 RGB LED strips with the maximum power rating of 3A
(12V).
» » The 5V_LED connector supports up to 300 LEDs WS2818B individually Addressable RGB LED strips
with the maximum power rating of 3A (5V).
» » Please use the Vivid LED DJ software to control the LEDs. For detailed software setting information,
refer to chapter 3.3 .

2.8 LEDs

Debug LED: Debug LED Indicators
This LEDs indicate the status of the motherboard.
Note
» » After starting the computer, the LED indicators will light up in the following order:
CPU → DRAM → VGA → BOOT
» » When the computer is ready, the LED indicator will show where the error occurred and will stay on
until the problem is solved.
» » After the computer is started, the Debug LED will not light up if there is no abnormality detected.
CPU - indicates CPU is not detected or fail.
DRAM - indicates DRAM is not detected or fail.
VGA - indicates GPU is not detected or fail.
BOOT - indicates booting device is not detected
or fail.
Chapter 2: Hardware installation | 23
B760M-SILVER