Biostar B760M-SILVER Manual page 16

Install M.2 COOLING Heatsink
Steps of Removing the M.2 COOLING Heatsink:
Step 1:
Before installing the M.2 SSD
card, remove the two screws on
the heat sink, and then remove
the heat sink.
Note
» » Please follow the installation instructions of M.2 COOLING Heatsink and remove the M.2 COOLING
Heatsink to install the M.2 SSD card onto your motherboard.
Install an Expansion Card
You can install your expansion card by following steps:
• Read the related expansion card's instruction document before install the expansion
card into the computer.
• Remove your computer's chassis cover, screws and slot bracket from the computer.
• Place a card in the expansion slot and press down on the card until it is completely
seated in the slot.
• Secure the card's metal bracket to the chassis back panel with a screw. (This step is only
• for installing a VGA card.).
• Replace your computer's chassis cover.
• Power on the computer, if necessary, change BIOS settings for the expansion card.
• Install related driver for the expansion card.
Note
» » Please be note that you will need to use M2 type screwdriver if you want to install or uninstall the
screw. It is recommended not to use a screwdriver that does not meet the specifications, otherwise
the screw may be damaged.
16 | Chapter 2: Hardware installation
Step 2:
Insert M.2 SSD card onto the
M.2 slot and screw it onto the
motherboard.
Step 3:
After installing the M.2 SSD card,
place the M.2 COOLING Heatsink
over the M.2 slot and fasten the
screws to fix the heatsink onto
the motherboard.