Table of Contents
Advertisement
TEMPErATUrE SETTING
Temperature can be set from 17 degrees to 37 degrees. Under heat mode, press
Temperature / Time Increase or decrease button " +, - ", auto switch to ECO mode, then
press Temperature / Time Increase or decrease button " +, - " to adjust the desired tem-
perature is displayed, the digit blinks for 3 seconds to confirm. Same operation for both
main unit control panel and remote controller.
Under Heating mode to turn off the appliance, the fan will continue run for around 15
seconds, please turn the main on/ off button after 15 seconds. Under fan mode, short
press on/ off button of the control panel to stop fan mode.
rEMOTE CONTrOLLEr
The remote controller use one Lithium battery, model No. CR2025 (3V). We recommend
using the Lithium type battery for longer use. Install battery as per below steps. Pull out
the bottom cover from the remote controller. Insert a Lithium battery and push back the
cover inside the remote controller. Please pay attention to the battery direction.
NOTE:
• Please follow battery disposal instruction on battery packaging, or contact your local
councils for safely disposal of batteries.
• One battery is included. Please pull out the insulating film before using the remote
controller for the first time.
OVErHEAT PrOTECTION
The appliance is protected with an overheat protection that switch off the appliance au-
tomatically in case of overheat, e.g. the whole or partial obstruction of the wind outlet or
back net. In this case, unplug the appliance, wait about 30 minutes to cool it and remove
the object which is obstructing the wind outlet immediately.
Then switch it on as described above after 30 minutes. The appliance should operate
normally. Should the problems persist, please contact our after sales service centre.
6
Advertisement
Table of Contents
