Table of Contents
Advertisement
OPErATING INSTrUCTION
1. Carefully remove the heater from the plastic bag and the carton.
2. Place the heater on a flat surface floor.
3. Turn the main ON/OFF button to "O" (off) at the back of the unit, plug the power cord
into AC 220-240V electrical outlet. Press the main ON/OFF button to "I" (ON)
position, the heater is in standby mode, LED display screen shows " _ "
4. Turn the heater ON by pressing the ON/OFF button "
controller. The unit is now in HIGH heat mode, display show "HI" with dark red indica-
tor. Press the ON/OFF button "
heater will switch off.
5. Pressing the Mode button "
Operation
Pressing once
Pressing twice
Pressing Third
Pressing Fourth
The ECO mode is turned on, the purple indicator light is on, and the screen shows 30ºC
(this is default setting). When the room temperature is close to 30ºC, the appliance will stop
heating and enter the standby mode. When the room temperature is lower than the set
value, the machine will restart the heating mode (Press the +, - temperature/time decrease
or increase buttons on the control panel or remote control to adjust the temperature).
OSCILLATING FUNCTION
This heater has an oscillating function. To Left & right switch the function on, press the
Left & Right oscillation button "
switch the function on, press the Up & Down oscillation button " ". To stop it, press the
button again. Same operation for both main unit control panel and remote controller.
NOTE: DO NOT adjust the angle position of the appliance hardly by hand to avoid
damage to the internal motor.
TIMEr FUNCTION
The timer function allows you to set the operation time from 1 to 24 hours.To set the
timer, press the TIMER button "
+,- to adjust the desired operation time is displayed. After the setting, the digit blinks for
3 seconds to confirm, display shows "h" indicator. To cancel the timer feature press the
button again until LED display screen show "
control panel and remote controller.
" on control panel / remote controller again. The
", the relating mode, indicator and display are as follows:
Mode
Low heat mode
ECO mode
Fan mode
High heat mode
". To stop it, press the button again. To up & down
". The LED display screen will show "
" at the control panel or remote
Indicator status
Light red
Purple
Blue
Dark red
" Same operation for both main unit
5
Display
Lo
ECO icon, 30ºC
No display
HI
". press
Advertisement
Table of Contents
