INSIGHT DLP SENSOR 500 Hardware Installation Manual page 11

9. Rear Panel Connections
Step 1: Connect the Ethernet cables.
Step 2: Connect any other required cables.
Step 3: Connect the power cords.
Step 4: Proceed to Section 10, Front Panel Operation on page 12.
NOTE: The server offers redundant, hot-swap capability. The connections
to AC mains should be made in a manner appropriate to local code and
consistent with customer power distribution with or without redundant
sources.
CAUTION
The power supply is only hot-swappable if you have a redundant system with
two power supplies installed. If you only have one power supply installed,
before removing or replacing the power supply, you must first take the server
out of service, turn off all peripheral devices connected to the system, turn off
the system by pressing the power button, and unplug the AC power cord
from the system or wall outlet.
INSIGHT DLP SENSOR 500 Appliance Hardware Installation Guide
(continued)
3 3
ID ID
eth4 eth4 eth5 eth5
eth4 eth4 th
eth5 eth5 th
1 1
SPAN SPAN PA eth3 eth3 th
DLP D D L P
MGM MGMT MGM GM T
MGMT MGMT SPAN SP AN DLP DLP eth3 eth3
eth6 eth6 eth7 eth7
eth6 eth6 th
eth7 eth7 th
2 2
www.insightdlp.com Page 11