Advertisement
TROUBLESHOOTING
You are getting
'VI Missing'
messages when
opening the NI
DAQ Test.
When performing
the NI DAQ Test,
the Analog Input
scope does not
read anything.
The Power LED
on NI M and X
Series Terminal
Board is not lit.
STILL NEED HELP?
Q2-USB
LEARN MORE
©2014 Quanser Inc. All rights reserved. LabVIEW™ is a trademark of National Instruments.
Review the following recommendations before contacting Quanser's technical support engineers.
•
Make sure you installed the LabVIEW™ add-ons listed in Step 3, such as the Quanser
Rapid Control Prototyping Toolkit®.
•
Make sure you made the RCA to RCA cable (analog loopback) connection on the
NI M and X series Terminal Board, as described in Step 4H.
•
Verify that you selected the correct NI DAQ device in HIL Initialize block in the
NI DAQ Test VI.
•
Load the Measurement and Automation Explorer (MAX) and confi rm that the NI DAQ
device name is under Devices and Interfaces. If not, make sure the software listed in
Step 3 has been installed.
•
Check that the Power LED is lit bright green on the DAQ terminal device.
If not, go to the next section.
•
Verify that the 68-pin shielded ribbon cable is fi rmly connected from the NI DAQ
device to the connector on the NI M and X Series Terminal Board.
For further assistance from a Quanser engineer, contact us at
tech@quanser.com or call +1-905-940-3575.
Full range of data acquisition devices from Quanser.
Q8-USB
Q8-USB
To find out about the full range of Quanser control experiments,
visit www.quanser.com
Q1-cRIO
QPIDe
V.2.2
Advertisement
