Quick Start Guide:
STEP 1
Check Components and Details
Make sure your Data Acquisition (DAQ) Device includes the following components:
1
3
STEP 2
Additional Components Required
To complete the NI Terminal Board set up, you will need the following:
RCP Toolkit
ni.com/labviewtools/rcp
STEP 3
Install NI LabVIEW™ Add-ons
Make sure LabVIEW™ and required add-ons are installed.
• LabVIEW™
• NI-DAQmx
• Quanser Rapid Control Prototyping Toolkit®
NI M and X Series Terminal Board
2
4
5
uSer MaNuaL
Ni M and X Series terminal Board
Captivate. Motivate. Graduate.
Solutions for teaching and research. Made in Canada.
Quanser Rapid Control Prototyping Toolkit for NI LabVIEW™
Visit www.ni.com/labviewtools/rcp
Note:
Note:
installed after LabVIEW. See the RCP Toolkit Installation Guide for
more information www.quanser.com/products/rcptk/documentation
1. NI M and X Series Terminal Board
2. NI PCI/PCI Express Data
Acquisition Device
3. 68-pin shielded ribbon cable
(NI SHC68-68, can be purchased
with NI PCI/PCIe DAQ device)
4. RCA to RCA (analog loopback) cable
(supplied with NI M and X Series)
5. Quanser Workstation Resources*
(includes User Manual and
Quick Start Guide)
Set Up and Configuration
*Download from the RCP Toolkit Resources
at www.ni.com/labviewtools/rcp.
Quanser educational solutions
are powered by:
must be purchased separately.
The Quanser Rapid Control Prototyping (RCP) Toolkit must be